Connections to be made – Metra Electronics CHTO-013 User Manual
Page 3
From the 16-pin harness:
• Connect the
Red wire to the ignition wire of the aftermarket radio.
• Connect the
Orange/White wire to the illumination wire of the aftermarket radio.
If the aftermarket radio has no illumination wire just tape off the
Orange/White wire.
• Connect the
White wire to the left front positive speaker output of the aftermarket radio.
• Connect the
White/Black wire to the left front negative speaker output of the
aftermarket radio.
• Connect the
Gray wire to the right front positive speaker output of the aftermarket radio.
• Connect the
Gray/Black wire to the right front negative speaker output of the
aftermarket radio.
• Connect the
Green wire to the radio’s left rear positive speaker output.
• Connect the
Green/Black wire to the radio’s left rear negative speaker output.
• Connect the
Purple wire to the radio’s right rear positive speaker output.
• Connect the
Purple/Black wire to the radio’s right rear negative speaker output.
• Connect the
Blue/White wire to the radio’s amp turn on wire.
• Connect the
Brown wire to the mute wire of the aftermarket radio. If the aftermarket
radio does not have a mute wire, tape up the
Brown wire.
• Connect the
Light Green wire to the parking brake wire of the aftermarket
navigation radio.
• Connect the
Blue/Pink wire to the VSS or speed sense wire of the aftermarket
navigation radio.
• Connect the
Green/Purple wire to the reverse wire of the aftermarket navigation radio.
• Plug the 16-pin harness into the CHTO-013.
3
Connections to be made
CHTO-013