Philips Magnavox MRD300 - Manual (Page 26)

24
English
Volume control
Adjust VOLUME button (or press VOL +/-) to
increase or decrease the volume level.
To listen through the headphones
● Connect the headphones plug to the PHONES n socket
at the front of the DVD system.
➜ The speakers will be muted.
To switch off the volume temporarily
● Press MUTE.
➜ “MUTE” icon appears.
● To restore the volume, press MUTE again.
Adjusting the speakers’ tones
and channels
(for discs with Dolby
Digital mode only)
You can change the speakers’ sound distribution to suit
your surround sound needs and adjust the treble/bass level
to define the sound-processor settings. For example, if you
are closer to the left front speaker than the right front
speaker, the left front speaker might seem “louder” than the
right one. To adjust it, you must change the channel level
for one or both speakers until the sound evens out.
1 While playing a disc, press SELECT repeatedly to select :
TREBLE LEVEL ™ BASS LEVEL ™ FRONT LEFT
™ CNT ™ FRONT RIGHT ™ SURROUND RIGHT
™ SURROUND LEFT™ SUBWOOFER
™ TREBLE LEVEL ...
2 While the level indicator appears on the display,
immediately press VOL +/- to select the desired treble,
bass or speaker’s level (-15~ +10.)
Helpful Hints:
– If the volume button is not used within five seconds, it will
resume its normal volume control function.
– If no button is pressed within a few seconds, the system will
exit automatically.
Dimming the display screen
You can change the brightness of the display panel on the
front of the DVD system.
● Press DIM to toggle between DIM 1, DIM 2 and DIM OFF
mode.
Selecting Listening mode
This DVD system has a built in Dolby Digital decoder.
When listening to a DVD with Dolby Digital signal
● Press LISTENING repeatedly to select :
Dolby Digital ™ Stereo
When listening to a DVD with PCM or 2-channel
signal
● Press LISTENING repeatedly to select :
Dolby Pro Logic ™ Stereo
When listening to a VCD, MP3-CD or audio CD
● Press LISTENING repeatedly to select :
Dolby Pro Logic ™ Stereo
Sleep timer setting
The sleep timer enables the system to switch to standby
mode automatically at a preset time.
1 Press SLEEP repeatedly to select a preset time.
➜ The selections are as follows (time in minutes):
120 ™ 110 ™ 100… ™ 20 ™ 10 ™ OFF
2 When you reach the desired length of time, stop pressing
the SLEEP button.
➜ “SLEEP” icon appears.
To check the remaining length of time after sleep
timer is activated
● Press SLEEP once.
To change the preset sleep timer
● Press SLEEP again while the remaining sleep timer is
shown.
➜ The display will show the next sleep timer options.
To deactivate the sleep timer
● Press SLEEP repeatedly until it reaches “OFF.”
OTHER FUNCTIONS
Other Functions