Faq & troubleshooting, Frequently asked questions, Troubleshooting – MartinLogan Depth subwoofer User Manual

Page 18: Requently, Sked, Uestions, Roubleshooting, Frequently asked questions troubleshooting

Advertising
background image

18 Frequently Asked Questions & Troubleshooting

F

REQUENTLY

A

SKED

Q

UESTIONS

& T

ROUBLESHOOTING

How do I clean my subwoofer?

Use a dust free cloth or a soft brush to clean your subwoofer.

We recommend a specialty cloth (available through the

Xtatic shop at www.martinlogan.com) that cleans better than

anything else we have tried.

Is it safe to set things on my subwoofer?

While your Depth is designed with a durable, stain-resistant

surface, we advise you not to set anything on your Depth—

especially containers holding liquids.

Is there likely to be any interaction between my sub-

woofer and the television in my Audio/Video system?

Yes. The Depth subwoofer doesn’t use shielded drivers.

Since the drivers are arrayed to balance the reactive force of

the woofers, their magnetic fields are also balanced. We

recommend 3 feet between the Depth subwoofer and

video components that are susceptible to magnetic fields.

Will my electric bill go 'sky high' by leaving my subwoofer

plugged in all the time?

No. The Depth, when the power switch is set to ‘Auto’ or

‘Standby’, will draw about 13 watts when idle.

Should I unplug my subwoofer during a thunderstorm?

Yes, or before. It's a good idea to disconnect all of your

audio/video components during stormy weather.

No Output

• Check that all your system components are turned on.

• Check that the power switch on the Depth is set to either

'Auto' or 'On'.

• Check your wires and connections.

• Check all interconnecting cables.

• Make sure the level control is not turned down.

• Turn off and unplug the Depth and check the fuse near

the AC power cord receptacle on the back. If the fuse

has blown, replace it with a matching, 5-Amp Slow-

Blow fuse.

• If the problem persists, contact your dealer.

Muddy Bass

• Check placement. Try moving the subwoofer closer to

the front and side walls.

• Check the type of feet that are being used. Try installing

the ETC spikes.

• Decrease the level.

• Decrease the 25Hz level.

• Check your processor setup.

• If the problem persists, contact your dealer.

Hums or Unusual Sounds

• Turn the Depth off, unplug all signal inputs, turn the

Depth back on and turn up the level. If the problem

disappears, the hum is originating elsewhere in your

system.

• If the problem persists, contact your dealer.

Frequently Asked Questions

Troubleshooting

Advertising