Martin Audio DX2 User Manual
Here takes you to a zip folder
All material © 2007. Martin Audio Ltd. Subject to change without notice.
Loading binary presets into your Martin Audio DX2
Loudspeaker Management System
Clicking
here takes you to a zip folder
containing the loader software and binary files.
Extract these to your hard disk. Do not run the programme from the zip folder.
Warnings
Loading presets will overwrite previously loaded factory presets - and any
changes to them (e.g. channel gain, delay, limiter settings).
To make a permanent record of changes to the user-editable parts of a preset,
you must save the preset in one of the lower number memory locations.
Make sure you have a full set of .bin files before proceeding so that you can
reload your original presets if you need to.
If you are not familiar with the Martin Audio DX2, please read the DX2
User Guide.
You should have extracted the following files to a suitable folder on your
hard drive:
MartinFlashLoader.exe – The DX2 binary preset loader software
MARTN1RLCDLC21801.bin – Binary presets for
W8LCD+W8LC+WS218X/W8LS combinations
MARTN1RLCDLCWLX01.bin – Binary presets for W8LCD+W8LC+WLX
combinations
MARTN1RLDLBLS02.bin – Binary presets for W8LD+W8L
Longbow+W8LS/WS218X combinations
MARTN1RLM218X03.bin – Binary presets for
W8LMD/LM+WS218S/W8LS combinations
MARTN1RLMWLX03.bin – Binary presets for W8LMD/LM+WLX
combinations
MARTN1RLMWMX03.bin – Binary presets for W8LMD/LM+WMX
combinations
MARTN1RLE12152101.bin – Binary presets for 4-mix LE1200, LE1500
or LE2100 systems