Micronics 60/66MHz - Manual (Page 19)

Installation of the M5Pi
The installation of the M5Pi system board depends on the type of case you
use. The M5Pi is a Baby AT size system board and you should be able to
install it in most cases.
Prior to installing the M5Pi, make sure you have a clear work space available
and adhere to all anti-static precautions.
If you are unfamiliar with installing a system board, Micronics highly recom-
mends you read the computer user’s manual or contact your dealer’s technical
support department.
Tools Required
Micronics recommends using the following tools to install the M5Pi:
m
Small Phillips screwdriver.
m
Tweezers or a pair of needle-nose pliers.
m
Tray (to hold loose screws).
Equipment Required
Micronics recommends using the following equipment with the M5Pi for a
typical configuration:
m
Chassis with standard hardware.
m
A high quality power supply capable of providing continuous power
within a 5 volt range, plus or minus 5% (eg. 4.75 to 5.25). A power
filter may be used with a noisy AC power source..
m
PS/2 compatible keyboard (PS/2 version).
m
AT-compatible keyboard (AT version).
m
Eight ohm speaker (included with most chassis).
m
Standard ribbon cables for internal connections.
m
Standard power cord (grounded).
m
Heat sink with cooling fan (required).
Micronics M5Pi System Board Manual
3-2