Micronics 60/66MHz - Manual (Page 26)

4
The BIOS Setup Utility
Configuration
After the M5Pi system board and all hardware is installed, the system is
ready for configuration. Before turning on the computer, make sure all
cables are correctly connected and all jumpers are correctly set.
It is recommended you keep the computer cover off the first time you
boot the system. If you have any difficulties, they will be easier to
correct.
Initial Boot Up
Power up the M5Pi. If the system doesn’t properly boot, check all your
cables and peripherals for bad connections. You may also get error
messages or beep codes. If this occurs, consult Appendices A and/or B
for a guide to possible solutions.
After the system properly boots, it is ready to be configured. The
following pages explain the proper procedures for BIOS configuration.
4-1