Micronics 60/66MHz - Manual (Page 27)

Setup
The Setup procedure is built into the system. Setup begins after the completed
system is powered up. Once the system is powered up and goes through a
memory test, the following screen appears on your monitor:
Figure 4-1 Power-Up Screen
If the systems detects a configuration error, it displays an error message. After
the error message, another message displays indicating the choice to “press
<F1> to continue (boot up), or <F2> to run the Setup procedure.” Normally,
you will press <Ctrl>, <Alt>, and <s> simultaneously to begin the Setup
procedure.
Micronics M5Pi System Board Manual
4-2