Quick installation, Micronics quick installation – Micronics 60/66MHz User Manual
Page 3
iii
Micronics Quick Installation
We know that many experienced people prefer to read as little of the documen-
tation as possible. If this sounds like you, here’s the short form:
1.
Ground yourself to prevent damaging static discharge, then remove
the M5Pi from its packaging.
2.
Configure and verify the system board’s jumper settings. (See
Jumper Settings in Chapter 2)
3.
Install the CPU and the system memory (Chapter 3).
4.
Install the system board into the system case and make all necessary
case connections.
5.
Install any ISA and PCI peripherals (Chapter 3).
6.
Turn the computer on and press <Ctrl>, <Alt>, and <s>
simultaneously after you see the screen below.
8.
Set the time and date. Adjust the BIOS settings to match your
configuration. If installing an IDE drive, select the IDE device you wish