Maintenance (engine), Danger – Multiquip Trash Pump QP4TZ User Manual

Page 25

Advertising
background image

QP4TZ TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (10/10/08) — PAGE 25

Maintenance

Perform the engine maintenance procedures as indicated below:

DAILY
■ Thoroughly remove dirt and oil from the engine and control

area. Clean or replace the air cleaner elements as necessary.
Check and retighten all fasteners as necessary. Check the
spring box and bellows for oil leaks. Repair or replace as
needed.

WEEKLY
■ Remove the fuel filter cap and clean the inside of the fuel

tank.

■ Remove or clean the filter at the bottom of the tank.

Figure 15. Engine Air Cleaner

DO NOT use gasoline as a cleaning solvent, because that
would create a risk of fire or explosion.

ENGINE OIL

1. Drain the engine oil when the oil is

warm

as shown in

Figure 14.

2. Remove the oil drain bolt and sealing washer and allow

the oil to drain into a suitable container.

3. Replace engine oil with recommended type oil as listed

in Table 5. Engine oil capacity is 1.6 quarts (1.5 liters). DO
NOT
overfill.

4. Install drain bolt with sealing washer and tighten se-

curely.

Figure 14. Engine Oil (Draining)

MAINTENANCE (ENGINE)

ENGINE AIR CLEANER

1. Loosen the wing nut and detach the cover of the air

cleaner shown in Figure 15.

2. Tap the element (Figure 15) several times on a hard surface

to remove dirt, or blow compressed air, not exceeding 30 psi
(207 kPa, 2.1 kgf/cm

2

), through the element side.

NEVER

wash the element with detergent because the element is oil-
soaked type. Replace the element when the output decreases
or bad exhaust color is noticed.

DANGER

DANGER

DANGER

DANGER

DANGER

Advertising