Mellerware 29800 - Manual (Page 2)

CONSTRUCTION
CONTROL PANEL
Please study these operating instructions before using
the coffee maker, and keep it for future use.
Using the machine for the first time
Before making coffee you should use the coffee maker
once with water only (without coffee or filter paper).
1.
Insert the plug into the socket.
2. Fill the glass jug with cold water, open up the
lid, and pour the water from the glass jug into
the water tank, then close the lid to its original
position.
3. Place the glass jug in its original position.
4. Note that the lid should be fitted securely.
5. Start the brewing process by pressing the on/off
switch.
Program Instruction
1. Display Function: four digit 24 hours display,
real time and pre-set timing. The red LED
indicates that the appliance is in the heating
condition, while the green LED indicates that
the appliance is on timer standby. When the
coffee maker is plugged into the wall socket,
and both LED’s are off, the display will show
the real time or any pre-set time.
2. Push Buttons
2.1 Press Button “on/off”: The appliance will start to
prepare coffee. The unit will turn off automatically
after 2 hours as a safety feature, and the LCD
will show the real time. Press this “on/off” button
when the green LED is on and it will cancel the
pre-set time.
2.2 “Auto” Button is the automatic on switch.
To pre-set the timer you must press the “pro”
button twice and start to set the required time,
then press the “pro” again to switch the appliance
in standby mode (with green LED on). Pressing
“auto” will cancel the pre-set timer program.
2.3 “Pro” program setting
2.3.1 Setting present time: plug in the appliance
and the system will show 12:00. Press and
hold the “pro” button for 3 seconds and the
word “set time” will show on the top left of the
LCD, then press “hr” to set hour and press
“min” to set minute. Press and hold the pro button
for 3 seconds again to exit the time setting.
If you do not, the pre-set time will be exit after 10
seconds. Unplugging the appliance will cancel
the preset present time, and resetting the time will
be required.
2.3.2 Setting of timer: press the “pro” button twice
to enter the “set timer” function, the word
“set timer” will show at the top right hand corner.
Press “hr” button for hours setting and press
“min” for minute setting. Press the “pro” button
to confirm and press “auto” button to switch
Glass Jug
Funnel Cover
Handgrip
Display
Funnel
Valve
Filter
Control Panel
Bottom Board
Water Spout
MAX
MIN
Water Tank Cover
Water Tank
Body