Motorola 3460 - Manual (Page 35)

3460 Fast’R
1-21
Installing/Removing Modem Cards
Installing a Modem Card
You can install 3460 Fast’R cards in an AccessWay while it is operating.
Figure 1-10. 3460 Fast’R Modem Cards
Installing a Modem Card in an AccessWay
Step Action
1. Loosen the enclosure front door screws. Open the door.
2. Flip the modem card’s ejector tabs (Figure 1-11) apart. Slide the
card into a slot’s guide rails. Press the tabs until it is seated
firmly and the tabs are against the rail. Ensure that the card front
panel is flush with the power module front panel.
3. If you plan to use Fast’RVu or a Motorola network management
system, install a card in Slot 9. A card must be present in Slot 9
to transfer network control information to and from modems.
Modem A
Modem B
Two-Wire Leased- or Four-Wire Leased-Line/Two- or Four-
Wire Dial-Line Modem Card
Dial-Line Dual-Modem Card