MartinLogan Purity Fully Powered Hybrid Electrostatic Loudspeaker - Manual (Page 24)

AC. Abbreviation for alternating current.
Active crossover. Uses active devices (transistors, IC’s,
tubes) and some form of power supply to operate.
Amplitude. The extreme range of a signal. Usually mea-
sured from the average to the extreme.
Arc. The visible sparks generated by an electrical discharge.
Bass. The lowest frequencies of sound.
Bi-Amplification. Uses an electronic crossover, or line-
level passive crossover, and separate power amplifiers for
the high and low frequency loudspeaker drivers.
Capacitance. That property of a capacitor which deter-
mines how much charge can be stored in it for a given
potential difference between its terminals, measured in
farads, by the ratio of the charge stored to the potential
difference.
Capacitor. A device consisting of two or more conducting
plates separated from one another by an insulating mate-
rial and used for storing an electrical charge. Sometimes
called a condenser.
Clipping. Distortion of a signal by its being chopped
off. An overload problem caused by pushing an amplifier
beyond its capabilities. The flat-topped signal has high levels
of harmonic distortion which creates heat in a loudspeaker
and is the major cause of loudspeaker component failure.
CLS. The abbreviation for curvilinear linesource.
Crossover. An electrical circuit that divides a full band-
width signal into the desired frequency bands for the
loudspeaker components.
dB (decibel). A numerical expression of the relative loud-
ness of a sound. The difference in decibels between two
sounds is ten times the Base 10 logarithm of the ratio of
their power levels.
DC. Abbreviation for direct current.
Diffraction. The breaking up of a sound wave caused by
some type of mechanical interference such as a cabinet
edge, grill frame or other similar object.
Diaphragm. A thin flexible membrane or cone that
vibrates in response to electrical signals to produce sound
waves.
Distortion. Usually referred to in terms of total harmonic
distortion (THD) which is the percentage of unwanted har-
monics of the drive signal present with the wanted signal.
Generally used to mean any unwanted change introduced
by the device under question.
Driver. See transducer.
Dynamic Range. The range between the quietest and
the loudest sounds a device can handle (often quoted in
dB).
Efficiency. The acoustic power delivered for a given elec-
trical input. Often expressed as decibels/watt/meter
(dB/w/m).
ESL. The abbreviation for electrostatic loudspeaker.
Headroom. The difference, in decibels, between the
peak and RMS levels in program material.
Hybrid. A product created by the marriage of two dif-
ferent technologies. Meant here as the combination of a
dynamic woofer with an electrostatic transducer.
Hz (Hertz). Unit of frequency equivalent to the number of
cycles per second.
Imaging. To make a representation or imitation of the original
sonic event.
Impedance. The total opposition offered by an electric
circuit to the flow of an alternating current of a single fre-
quency. It is a combination of resistance and reactance and
is measured in ohms. Remember that a speaker’s imped-
ance changes with frequency, it is not a constant value.
G
LOSSARY OF
A
UDIO
T
ERMS
24 Glossary of Audio Terms