Mark Levinson CD Processor N390S - Manual (Page 4)

Specifications are subject to change without notice.
Mark Levinson ® is a registered trademark of
Harman International Industries, Incorporated.
Not responsible for typographic errors.
Part # 072-16155
Nº390S CDProcessor
Frequency Response: 10Hz - 20kHz, +0dB, -0.3dB
Total Harmonic Distortion:
(THD)
0.002% @ 1kHz, 0dBFS (10Hz - 30kHz)
Dynamic Range: 96dB (10Hz - 30kHz)
Signal-to-Noise Ratio: 105dB (10Hz - 30kHz)
Channel Separtion: Better than 110dB
Intermodulation Distortion:
(SMPTE IMD)
Less than 0.005%
Maximum Output: 4.45V balanced
(0 dBFS signal) 2.225V single-ended
Volume Control:
(attenuation) Range
61.2 to +12dB
Digital-to-Analog
Conversion:
Dual differential 24-bit DACs
Conversion Rate: 352.8kHz or 384kHz (input signal dependent), 24-bit
Analog Filter: Bessel-tuned, linear phase to 40kHz
Low-level Linearity: Deviation less than 2dB to below -90dBFS less than 2dB to below -102dBFS w/20-bit input
Output Impedance (analog): 10
Ω
Direct Digital Output, XLR: AES/EBU 110
Ω
, 3.5V
Direct Digital Output, RCA: S/PDIF 75
Ω
, 0.5V
Mains Voltage: 100V, 120V, 200V, 220V, 240V, factory set for destination country
Mains Frequency: 50 or 60Hz, factory set for destination country
Power Consumption: 36 watts maximum
Overall dimensions: width: 15.75" (40cm)
height: 3.84" (9.75cm)
depth: 14.3" (36.3cm)
20.56" (52.21cm) with loader open
Input Complement: (1) EIAJ digital input
(1) S/PDIF (RCA) digital input
Output Complement: (2) male XLR balanced audio outputs
(2) RCA single-ended audio outputs
(1) AES/EBU (XLR) digital output
(1) S/PDIF (RCA) digital output
Other I/O: (2) RJ-45 modular Communication Links
(1) 3.5mm external IR input jack
(1) IEC AC mains connector
Shipping Weight: 50lbs (23kg)
3 O a k P a r k , B e d f o r d , M A 0 1 7 3 0 - 1 4 1 3 U S A
T e l : 7 8 1 - 2 8 0 - 0 3 0 0 | F a x : 7 8 1 - 2 8 0 - 0 4 9 0
w w w . m a r k l e v i n s o n . c o m