Marantz STRIKER S160 - Manual (Page 16)

1 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
m
aximizing
y
our
s
Tove
’
s
o
verall
e
fficiency
It is important to know that for high, combustion efficient,
clean burns, you will need to have sufficient temperatures
inside the firebox for thorough combustion. The best method
for determining if you have sufficient temperatures is to
watch the brick lining in your firebox. When you first light
your stove, the bricks will turn a dark brown or black. After
20 to 30 minutes of a hot fire, most of the bricks should
return to near their original light brown or yellow color. This
means the bricks have reached a high enough temperature
for your stove to achieve high combustion efficiency.
Second, and just as important, is achieving a high level
of heat transfer efficiency. Slowing the rate of flow through
the stove or insert enhances heat transfer, thus allowing
more time for heat to be transferred into your home. To
do this, be sure to thoroughly preheat your stove and then
reduce the amount of primary air by closing the draft con-
trol (lower left) to about 1/2 to 3/4 open. This will decrease
the excess oxygen in your flue, which carries heat up your
chimney, but should still be enough air to allow the stove to
produce its maximum heat output. (More air may produce
a lightly greater amount of heat, but will greatly increase
wood consumption). When the area being heated reaches
a comfortable temperature, slow the burn rate by closing
the control to further improve heat transfer.
To get the most out of your Country™ Collection stove,
you will need to combine good combustion efficiency with
good heat transfer practices. The following are some tips
on how to operate your stove to achieve the highest overall
efficiency.
1. Thoroughly preheat your stove before slowing the
burn rate by closing the draft control.
2. Measure the stove temperature at the hottest point on
the stove top or face. Use this information to repeat
burn rates.
3. Once preheated, add wood (if needed) and partially
close the draft control (lower left).
4. Operate your stove as much as possible in the low to
medium burn ranges.
5. Do not lower the draft setting so low as to completely
extinguish the flames in the firebox. Check for at least
some small flames 20 minutes after setting the draft
control.
6. Do not continually operate your stove in the high
(wide open) setting. This wastes wood by carrying
a great deal of heat up the chimney and can damage
your stove and chimney.
7. Go outside and check your chimney. More than a
very small amount of smoke indicates wasted heat,
creosote build-up, and pollution.
a
chieving
c
lean
, l
ong
B
urns
To achieve long burn times, after having thoroughly pre-
heated the stove, let the stove top cool down to  to 00
degrees (on Elites, locate thermometer on the face of the
insert just above the door). Now load the firebox and set the
draft control. At this point, you may need to burn the stove
with the draft open for a few minutes to ignite the wood. All
Country Collection stoves are EPA tested for emissions at low
burn with the air control completely closed. Whether or not
you should burn your stove with the air control completely
closed will depend on the following factors.
* How you load your wood.
* Your chimney type, height, and draft.
* Your wood type and its moisture content.
* The temperature of the stove.
* Which model Stove or insert you have.