Philips Magnavox TS2746C1 - Manual (Page 21)

MUTE
CC
A/CH
SLEEP
VOL VOL
CH
CH
MENU
1 2 3
4 5 6
7 8 9
0
STATUS/EXIT POWER
1
8
4
3
6
5
7
2
INPUT ON
SLEEPTIMER OFF
SmartLock ᮣ
CC OFF
SETUP ᮣ
SmartLock
ACCESS CODE
_ _ _ _
SmartLock
ACCESS CODE
X X X X
SmartLock
ACCESS CODE
_ _ _ _
INCORRECT CODE
BLOCK ᮣ
CHANGE CODE ᮣ
CHANGE CODE X X X X
CONFIRM CODE X X X X
U
NDERSTANDING THE
S
MART
L
OCK TM C
ONTROL
(A
CCESS
C
ODE
)
Parents - it isn’t possible for your child
to unblock a channel without knowing
your access code or changing it to a
new one. If your code changes, and you
didn’t change it, then you know it’s been
altered by someone else and blocked
channels have been viewed.
O ver the next few pages you’ll
learn how to block channels
and get a better understanding of
the rating terms for certain
programming. First, let’s start by
learning how to set a personal
access code:
Press the MENU button on the
remote to display the onscreen
menu.
Press the CURSOR UP ▲ or
CURSOR DOWN ▼ buttons
until the words SmartLock are
highlighted.
Press the CURSOR RIGHT
ᮣ button to display the
SmartLock Access Code screen.
Using the NUMBERED but-
tons, enter 0, 7, 1, 1. “XXXX”
appears on the Access Code screen
as you press the numbered buttons.
“INCORRECT CODE” will
appear on the screen, and you will
need to enter 0, 7, 1, 1 again.
Press the CURSOR DOWN ▼
button until the words CHANGE
CODE are highlighted.
Press the CURSOR RIGHT ᮣ
button to change your personal
Access Code.
“Next enter a “new” 4 digit
code using the NUMBERED but-
tons. The screen will then ask you
to confirm the code you just
entered. Enter your new code
again. “XXXX” will appear when
you enter your new code.
Press the STATUS/EXIT
button to save the new code
in the TV’s memory.
Continue to the next page to learn
how to block channels from viewing.
BEGIN
NOTE: The 0,7,1,1 access code shown
on this page is the default code or a
way to reset the code when the current
access code is not known.