M&S Systems Home Theater System - Manual (Page 3)

The subwoofer for the Mini-Cube Home Theater Package has an 8”
active woofer. It is available in a black matte finish.
RMS Power Rating 100 Watts
Frequency Response 40 Hz to 350 Hz
Crossover 40 Hz to 180Hz (Adjustable)
Controls Power, Volume, Crossover
Frequency, Phase
Connections RCA Jacks and Spring Terminals
Height 13.3 “
Width 9.8 “
Depth 13.7 “
Weight 20 lbs.
UNPACKING YOUR SPEAKERS
After carefully unpacking your speakers, the carton and the packing
material should be saved for possible use later. If any speaker appears
to be damaged, do not attempt to repair or to connect the unit to the
amplifier. Repack the speaker and notify your distributor or M&S
Systems for replacement or repair.
SPEAKER PLACEMENT
The cube units can be mounted on the ceiling or walls of the room,
therefore, many combinations are possible. The MNC or the front and
rear cube speakers of the MNCS package should be separated by 6 to 8
feet for good stereo separation. They should not be any closer than 2
feet to any adjacent surface (wall or ceiling). The cube brackets should
be attached to a stud or mounted anchor with bolts to provide secure
mounting.
NEVER MOUNT THE BRACKETS TO SHEETROCK
WITHOUT SOME TYPE OF ANCHOR. The placement of the center
channel and the subwoofer (MNCS system only) are not as critical. The
center channel is best located on top of the TV cabinet or on a shelf
above the TV. The subwoofer should be placed near a corner at the front
or rear of the room for best bass sound.
The MNC unit is designed with a swivel joint between the two speakers.
Each speaker can be aimed individually. The unit also comes with a
mounting bracket for attachment to a wall or ceiling. The bracket screws
into the threaded socket on the bottom of the unit, and may be adjusted
so that the speakers point in the desired direction. (See figure 1)
Note: When mounting speakers from wall surfaces additional tightening
of the hex screw may be required.
2 of 7