Marmitek SWM1P - Manual (Page 2)

© M A R M I T E K 2 2 7 5 2 / 2 0 0 8 0 5 0 4
Functions
www.marmitek.com
Job no. Filename
Colours
SWM1P AZ.ai
22-05-2008
CYAAN MAGENTA YELLOW BLACK
Voltage: 230 V AC+/- 10%, 50 Hz
Switching capacity: 500W/230 VAC with temperature and
mounting restrictions.
Protection: Continuous driving time maximum
4 minutes.
Output temperature protected.
Use: < 1 W
Fuse: Radial lead micro fuse, 4 AT.
Power consumption: < 30 mA capacitive
Signal transmission: > 5 Vpp in 5 Ω at 120 kHz
X-10 transmission: 1 pulse at 0° and 180°
Signal sensitivity: 5 mVpp…6 Vpp at 120 kHz ± 4 kHz
Signal to noise ratio: 1.35 : 1
X-10 Key codes
transmitting: ON,
OFF, extended
X-10 Key codes
receiving:
ON, OFF, DIM+, DIM-, extended,
Status Request
Connection range: Up to 2.5 mm 2 , tightening moment
0.5 Nm
Ambient temperature: 0 °C to 35 °C
Relative humidity
(non condensing):
30 to 90%
Dimensions (LxWxH): 46x46x16mm.
Technical data SWM1P
Order information
SWM1P Art.nr. 09779
Boxsize (LxWxH) 90x37x144mm
Also available
CM15Pro™ Computermodule
EU VERSION Art. Nr. :09793
UK VERSION Art. Nr. :09800 In-wall double 2-way
momentary switch
(4 make-contacts)
Jung CD500 style Alpine White
Art. Nr.:09811
• Sunblind module (micromodule) for installation behind a
momentary switch or in a junction box.
• Driving of one 230Vac motor with at most 2.5 A.
• Reacts to ON, OFF, DIM+, DIM- and extended sunblind
commands.
• One free programmable address A1…P16 for operation.
• One free programmable address A1…P16 for the Preset
mode.
• Preset function for programming of a preference position.
• Possibility for controlling multiple SWM1P modules at once
to one preference position using the Preset function.
• Local lock function for inhibiting the operation of the
motor, for instance during maintenance.
Local controls
• Any 2-way momentary switch
With 2 make-contacts (Up/Down function).
• Any double 2-way momentary switch
With 4 make-contacts (Up/Down, Preset and Lock function).
Multiple roll-down shutters with one
Preset mode
Program the Preset address of all sunblinds in for instance the
living room to the same address. With the Preset key of any
sunblind modules in this room or by means of sending the
Preset address ON via a Marmitek interface all sunblinds can
be set to the Preset mode simultaneously.