Magnadyne M2080 - Manual (Page 5)

5
Radio Operation
1. To turn on the unit, push in the power button.
2. Select either AM or FM radio by using the AM/FM band button.
3. Use the radio tuning knob to select the desired station.
4. Adjust the volume, tone and balance controls to suit your
listening taste.
5. To turn the unit off, simply push the power button.
Tape Operation
1. Insert a cassette into the cassette door with the tape exposed side
facing the right. The cassette will only fit in one way, so if it does
not fit the first try, do not force it! Turn the cassette over and try
inserting it again.
2. Adjust the volume, tone, and balance to your listening taste.
3. To fast advance the tape, press the "FF/EJ" button until it clicks.
Press the button lightly to release it. Press the "FF/ EJ" button all
the way in to stop the tape and eject it from the mechanism.
Antenna Trimmer Adjustment
The trimmer is factor y adjusted. However, it may require
readjustment depending on the type of antenna which is
employed. If AM reception is poor, adjust the trimmer for
maximum output. Fully extend the antenna, tune to a station
around the 1400kHz spot on the dial. Then insert a flat screwdriver
into the rear of the chassis and carefully adjust the antenna
trimmer for maximum output.
FM
88 92 9
6 1
00 1
06 1 08
MHz
BA L
TO NE
MIN
MAX
R L
L
10 14
1 6
x100 KHz
Controls and Operation
Antenna
Trimmer
M2080 English 08/04/00 7:51 AM Page 5