Multiquip SideWinder Cut-Off Saw HS81 User Manual
Page 21
HS81 CUT-OFF SAW — OPERATION & PARTS MANUAL — REV. #4 (09/12/05) — PAGE 21
HS81 CUT-OFF SAW — WATER KIT INSTALLATION PROCEDURE
Figure 21. Water Kit Parts
Figure 22. Water Kit Assembly Points
Figure 23. Wet Air Filter Canister
Water Kit Installation Procedure
Connect the
Quick Disconnect Fitting
I
to the
single end of the
Water Hose
J
.
Snap fit the
Water Hose
Outlets
J
to the
Holes
in the
Blade Guard
. Orient the
Water Hose
J
through the
Front Handle.
!
Loop the
Hose Clamp
G
around the
Water Hose
J
and fasten the clamp to the
Roller Bar Support Arm
using the Socket Head Cap Screw w/ Washer
H
, and
Hex Key Tool
K
.
"
Use the
Plastic Ties
L
as preferred to further secure
the hose fittings and water hose to the saw.
#
When using the Water Kit option for your saw, the Dry
Air
Filter Canister
MUST be replaced with the Wet
Air Filter
Canister
M
(See page 54, Item 10).
Contents of Water Kit
The contents of the Water Kit cannot be purchased seperately.
See page 63-63 for Water Kit part number.
Hose Clamp
G
Socket Head Cap Screw w/ Washer
H
Quick Disconnect Fitting
I
Water Hose
J
Hex Key Tool
K
(Included with Tool Kit, page 64, Item 1)
Plastic Ties
L
Wet
Air Filter Canister
M
(Sold Seperately)