Magnadyne MV-1002 - Manual (Page 8)

Viewing Screen Controls and Functions
7. Transmitter Frequency Selection:
The Movievision TM viewing screen transmits a signal that
is received by the Movievision TM headphones and can also
be received by the vehicle’s car radio. There are 3 fre-
quencies available for use but only one can be used at a
time. When you are listening to a movie using the wireless
Movievision
TM headphones, it is possible that you could
travel through an area where interference between the
screen transmitter and the headphone receiver is at an un-
acceptable level. If this occurs, you can use the 3 position
frequency switch located in the roof housing to select a
different frequency that may have less or no interference.
Each time you change the transmitting frequency, the
headphone/car radio receiver will have to be re-tuned to
the new frequency. The 3 frequencies available for use are
89.7mhz, 90.1mhz or 90.5mhz. (For further information
on headphone tuning, consult the “Headphone Operation”
section of this manual)
Car Radio Interface:
The signal transmitted from the Movievision TM screen can
be received by the existing FM car radio. This
listening mode provides a much higher quality of sound for
all. To listen to the Movievision
TM signal through the vehicle
stereo system, repeat the following procedures;
A. Turn “ON” the Movievision TM system and insert a tape or
attach an auxiliary signal source to view on the screen.
B. Turn “ON” the FM radio in your vehicle and tune the
radio to one of the 3 frequencies transmitted by the
Movievision
TM system. (89.7mhz - 90.1mhz - 90.5mhz)
C. Adjust the volume and tonal qualities to suit your lis-
tening taste.
Transmitter Frequency Selection Switch
Domelight Operation
Domelight Operation:
(Applies to MovieVision flip-down screen with domelights
built-in only.)
The domelights located in the MovieVision screen housing
will illuminate whenever the vehicle doors are open just as
the original domelight did.
To activate the domelights while the vehicle is in motion,
press the domelight switch next to the desired domelight.
Note: Most American made vehicles (Ford, Chevrolet, Dodge)
have a dashboard light dimmer switch that can be rotated to
the maximum position and the domelights will illuminate.
Most Japanese or Korean made vehicles do not have this
switch and the lights will have to be turned on manually as
mentioned above.
Domelight
Switch
8
MV-VCR102UM 1/17/02 10:01 AM Page 8