MicroBoards Technology CWR-424-52 - Manual (Page 4)

CWR-424-52
Microboards Technology LLC
Setting up the CWR-424-52 duplicator
Set up the CWR-424-52 duplicator with the following conditions:
• 19” Rack mount position or
•
On a level and stable surface
• In a well ventilated location
• Temperature and humidity:
o Temperature: 5-40° C
o Humidity: 20-80%RH (no dew formation)
Do not locate the CWR-424-52 duplicator:
Under direct sunlight (If the machine is exposed to sunlight, the light should be blocked by
a curtain or blind.)
In a place where there is a lot of vibration
Near open flame
In a place where the temperature and humidity change drastically
Near a heating device such as a heater or furnace
In a location where air from an air conditioner blows directly onto the unit
Near a container filled with water such as a vase
In a dusty location
o
Dust and dirt can decrease the productivity of the duplicator dramatically. It is very
important to keep the system in a clean and dust free environment.
In winter during times of low humidity or in a location where static electricity is
generated, use an anti-static-electricity mat or humidifier to prevent static electricity .
Copy Process
The advantage of the CWR-424-52 is the quick and easy operation to burn CD information.
You can burn CD-R’s by pressing the button only once with the CWR-424-52 as follows;
Turn on CWR-424-52, and it begins to initialize.
o The LED’s turn on, one at a time and then go off, leaving the 1
st mode light on.
o Insert a Master disc into the Master drive and blank discs into writers.
o Wait for ten seconds until the drives are ready.
o Press the ‘START’ button (press it once).
o The copy process begins.
Refer to the “LED’s Status” and “Copy Mode Process” sections for details.
Using Audio Masters:
When copying Audio masters with a large number of tracks, the system can take 3 to 5 minutes to
4