Philips Magnavox MWC20D6 - Manual (Page 6)

EN
6
P
REPARATION FOR USE
ANTENNA/CABLE CONNECTIONS
NOTE:
Before plugging the antenna into
the ANT. jack of the unit, check
that the pin is not bent. If it is bent,
straighten the pin as illustrated,
then plug the pin into the ANT. jack
of the unit.
Bent pin
Cable Plug
(Needs to be
straightened)
(Straight pin)
For your safety and to
avoid damages to the unit,
unplug the antenna cable
from the ANT. jack before
moving the unit.
Use the AUDIO/VIDEO input jacks on the front of the unit when connecting your TV to an
external video device (VCR, Camcorder or Game Console).
Connect the Audio/Video output jacks of the external source to the AUDIO L/R and VIDEO
input jacks of this unit.
Then use [SELECT] or [CH. K
K / L L ] until "AUX" appears on the screen.
(Refer to "TO WATCH EXTERNAL INPUT" on page 9.)
NOTE:
When you connect a monaural VCR (external source) to this unit, connect the Audio output jack of the monaural VCR
(external source) to the AUDIO L jack of this unit. The audio will output in both L and R channel equally.
AUX
CONNECTING TO AN EXTERNAL DEVICE (FRONT)
Plug the incoming cable into the ANT. jack on the rear of the unit.
If your cable service supplies you with a converter box or if you use a satellite system, connect the box with
this unit as shown below.
ANT. COAXIAL
ANT.
Cable
TV signal
Antenna
or
IN
OUT
Rear of the unit
*NOTE
(DO NOT DISCONNECT FROM BOX)
Some cable TV systems use scrambled
signals and require a special converter to
receive these channels. Consult your local
cable company.
OR
Incoming cable from home
Antenna / Cable Company
(No Cable Box)
Incoming cable from Cable Company
or Satellite Antenna
Cable Box or Satellite Box*
ex.
VCR or video camera, etc.
[Front of the unit]
To the Audio output jacks
To the Video output jack
(OUT) (IN)
(OUT)
(IN)
Audio Cable
(commercially available)
Video Cable
(commercially available) • To connect a headphone
(not supplied) for personal
listening.
ex.
Headphone
T9206UG(EN).QX4 06.7.24 6:14 PM Page 6