Ar13d ride-on roller — operation – Multiquip RIDE-ON TANDEM DRUM ROLLER AR13D User Manual

Page 26

Advertising
background image

PAGE 26 — AR13D RIDE-ON TANDEM DRUM ROLLER — OPERATION & PARTS MANUAL — REV. #2 (09/15/11)

AR13D RIDE-ON ROLLER — OPERATION

OPERATION

Parking Brake

1. To release the parking brake, press and hold the release

button (Figure 21) pull up slightlyon the parking lever, then
push the parking brake lever all the way down.

Shift Lever

1. To make the roller move in a

forward direction

, move the

shift lever forward as shown in Figure 22.

Figure 22. Shift Lever

2. Remember the speed of the roller is directly proportional to

the amount of pressure being applied to the lever in each
direction. Travel speed is between 0 and 4.8 mph (7.2 kph).

3. Try manuvering the roller a few times to get familar with the

handling. Also place the travel lever in the oposite direction
to get acquainted with driving in reverse.

4. Make sure that the roller comes to a complete stop (neutral)

before placing the travel lever in either a forward or reverse
position.

Vibration Button

1. To begin the vibratory action,

press

the vibratory

pushbutton switch located on top of the travel lever as
shown in Figure 23. The pressing of this switch will
generate 3,100 lbs. (1,406 Kg.) of centrifugal force at a
frequency of 4000 vpm (vibrations per minute) to the

front

drum.

ALWAYS

allow the roller to come to a complete stop before

changing the direction of travel. Changing directions before
the roller comes to a complete stop will result in

excessive

force

being applied to the transmission and drive system,

which will reduce the over service life of the system.

Figure 24. Sprinkler Controls

Figure 21. Brake Release Lever

FRONT

BACK

Sprinkler Controls

1. If the application requires the wetting of a surface, front and

rear drum sprinkler controls have been provided. These
controls (Figure 24) are located to the bottom right of the
operators seat. The

front

valve controls the water supply to

the front drum spray bar and the

back

valve contols water

flow to the back drum spray bar.

2. To stop the vibratory action, press the vibratory pushbutton

switch again.

Figure 23. Vibration Pushbutton Switch

CAUTION - Drive System Safety

Advertising
This manual is related to the following products: