Minolta magicolor 330 - Manual (Page 5)

3
1 Using the Parts List
1. The numbers shown in each illustration correspond to the parts list number for that illustration.
2. Throughout this manual, parts are identified by the prefix “PL”, followed by a number, a decimal point, and
another number. For example, PL3.12 means the part is item 12 of Parts List 3.
3. The capital letters “C”, “E”, “KL”, and “S” shown in an illustration stand for C-ring, E-ring, Clamp, and
Screw, respectively.
4. A shaded triangl ▼ in an illustration indicates the item is part of an assembly.
5. The notation “with X~Y” following an part name indicates an assembly that is made up of components X
through Y. For example, “1 (with 2~4)” means part 1 consists of part 2, part 3, and part 4.
6. The symbol $ following a part name indicates the part is an FX Recommended Part and is constantly
stocked and readily available. Other parts may be stocked according to the needs of each individual OEM
client.
7. An asterisk * following a part name indicates the page contains a note about this part.
8. The notation “J1<>J2 and P2” is attached to a wire harness. It indicates that connector jack 1 is attached
to one end of the wire harness and connector jack 2 is attached to the other end that is plugged into plug 2.