Philips Magnavox 701P41586 - Manual (Page 18)

10 Chapter 1 Installing Plotter Driver
1.3
Driver Operation Reference
The driver setup information set in the “Preferences” box at driver installation can also
be changed when the PLOT command is executed.
Change Driver Setup
1
Execute the PLOT command to open the “Print/Plot Configuration” dialog.
2
Click the “Device and Default Selection” button.
3
Select the 6030/6050 printer.
4
Click the “Change” button at “Device Requirements” in the opened dialog
box.
5
The “Change Device Settings” dialog box opens. This is similar to the dialog
box displayed at the driver installation. The driver setup information can be
changed with this dialog box.
This dialog box is almost the same as the “Device Setup” dialog box.
Select paper type: Select type of paper to be used from “Bond”, “Film”,
“Vellum” paper and “Use plotter setting”.