Miele CVA 4070 - Manual (Page 47)

The unit suddenly turns off.
– Is the machine programmed to
switch off after a programmed
time?
– The water temperature could be to
high.
– There could be pebbles within the
coffee beans. The unit shuts off
after 20 secs. to avoid damages.
– Is the machine plugged in?
– The machine goes into standby mode
when not used for a programmed time.
See "Settings - Timer - Turning off after".
– The unit is locked until the water has
cooled.
– Call Miele's Technical Service
Department.
– Plug in the machine.
The door cannot be closed.
Check if all containers are properly inserted.
The door is hard to open and close, and the gasket of the connector is
pulled off.
Adjust the door with the door hinges. See "Installation - Adjusting the door
hinges".
The gasket of the coffee dispenser connector is damaged and leaking.
– The gasket is worn.
– Check the door. Is the alignment
off from damage to the gasket?
– Change the gasket with a new one
(supplied).
– Adjust the door with the door hinges.
See "Installation - Adjusting the door
hinges".
The grind control lever will not move.
Close the unit and prepare a coffee/espresso. The grind grade can now be reset.
The brew unit cannot be taken out.
The brew unit is not in the correct
position. Close the door and turn the appliance on.
The brew unit will position itself into the
correct position.
The cover of the ground coffee funnel cannot be pushed in properly.
Close the lid of the ground coffee funnel.
Frequently asked questions
47