Memorex MP3823 - Manual (Page 11)

10
Open the Cassette Door and
insert a good quality blank
cassette tape into the slots on the
door, with the open end facing up
and the full reel on the right-hand
side. Close the Cassette Door.
Full Reel on Right
Open Surface Side
1
When you are ready to begin
recording, press the RECORD ( )
button. The PLAY (➛) button will
also engage. The tape will begin
moving and all of the material from
your selected source will be
recorded on the tape.
3
Rotate the FUNCTION control to
select the function you wish to
record, either RADIO or CD, and
operate that function according to
its own instructions.
2
MAKING A TAPE RECORDING
The tape recorder in this system allows you to make direct recordings from the radio or CD player to a blank
cassette in the tape compartment. An automatic recording volume level control (ALC) circuit will automatically
control the volume level of your recordings to prevent distortion. You may change the settings of the volume
or the Stereo-Wide controls during a tape recording, as these controls have no effect on the material being
recorded onto the tape.
To make a tape recording, proceed as follows:
To avoid recording unwanted
material, such as radio
commercials, use the PAUSE ( )
button to stop the recording
temporarily. Release the PAUSE
( ) button to begin recording
again.
4
If you wish to listen to your
recording immediately, press the
cassette REWIND (❿❿) button ❶
until the tape rewinds to the
beginning, then press the STOP
(■ ) button ❷ . Rotate the
FUNCTION control ❸ to the
TAPE position and press the
PLAY (➛) button ❹ to begin
playback.
4
1
2
3
6
When you are finished recording,
press the STOP (■) button to
stop the tape.
5
CASSETTE TAPE OPERATION (CONTINUED)
MP3823 O/M.QXD 4/30/02 10:57 AM Page 10