Magnadyne MV-IPAD2 - Manual (Page 10)

10
Wiring
Power Harness Wiring:
The 4-wire harness provides battery and ignition (12
volts DC) as well as a chassis ground. Route the
power harness to the point in the vehicle that you will
make the connections.
Red Wire: The red wire in the harness should be con-
nected to a +12 volt power wire that is turned on and
of by the position of the ignition key.
Yellow Wire: The yellow wire in the harness should
be connected to a constant +12 volt wire that is NOT
turned on and off by the position of the ignition key.
Black Wire: The black wire in the harness should be
connected to the chassis of the vehicle using a ring
terminal and self tapping screw or bolt and nut.
White Wire: Connect to the common trigger wire
coming from all door pin switches. Using the switch
on the docking station housing to select either nega-
tive or positive door trigger.
Negative
Trigger Door
Switch
Positive
Trigger Door
Switch
Dome light Trigger
BlackW ire - Ground
Red Wire - Ignition
Yellow Wire - Battery
White Wire - Door
2A