8 power specifications, 1 power consumption, Power specifications 2.8.1 – Maxtor DIAMONDMAX 21 PATA STM3300620A User Manual

Page 19: Power consumption

Advertising
background image

DiamondMax 21 PATA Product Manual, Rev. B

13

2.8

Power specifications

The drive receives DC power (+5V or +12V) through a four-pin standard drive power connector.

2.8.1

Power consumption

Power requirements for the drives are listed in the table on page 13. Typical power measurements are based
on an average of drives tested, under nominal conditions, using +5.0V and +12.0V input voltage at 25°C ambi-
ent temperature.
• Spinup power

Spinup power is measured from the time of power-on to the time that the drive spindle reaches operating speed.

• Seek mode

During seek mode, the read/write actuator arm moves toward a specific position on the disc surface and does
not execute a read or write operation. Servo electronics are active. Seek mode power represents the worst-
case power consumption, using only random seeks with read or write latency time. This mode is not typical
and is provided for worst-case information.

• Read/write power and current

Read/write power is measured with the heads on track, based on a 16-sector write followed by a 32-msec
delay, then a 16-sector read followed by a 32-msec delay.

• Operating power and current

Operating power is measured using 40 percent random seeks, 40 percent read/write mode (1 write for each
10 reads) and 20 percent drive idle mode.

• Idle mode power

Idle mode power is measured with the drive up to speed, with servo electronics active and with the heads in
a random track location.

• Standby mode

During Standby mode, the drive accepts commands, but the drive is not spinning, and the servo and read/
write electronics are in power-down mode.

Table 4:

DC power requirements

(TBD) (values taken from DM21 SATA specs)

*During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and

power to operational levels.

Power dissipation

Avg (watts 25° C)

Avg 5V typ amps

Avg 12V typ amps

Spinup

2.8 (peak)

Idle*

9.30

0.611

0.520

Seeking (random, 20% idle)

12.60

0.613

0.795

Standby and Sleep

0.80

0.106

0.023

Advertising