Mdr-9d — inspection, Caution, Danger – Multiquip Mikasa Vibratory Walk-Behind Roller MDR-9D User Manual

Page 18

Advertising
background image

PAGE 18 — MQ-MIKASA MDR-9D VIBRATORY ROLLER — OPERATION AND PARTS MANUAL — REV. #0 (12/17/03)

MDR-9D — INSPECTION

CHECKING ENGINE OIL LEVEL

1.

Make sure that the machine is situated in a flat
surface so that level measurements will be accurate.

2.

Pull out the dipstick from the oil tank (Figure 8).

CHECKING FUEL

1. Remove the fuel cap located on top of fuel tank.

2. Visually inspect to see if fuel level is low. If fuel is low, replenish

with diesel fuel (Figure 9).

3. When refueling, be sure to use a strainer for filtration. DO

NOT top-off fuel. Wipe up any spilled fuel.

Figure 8. Oil Dipstick

DO NOT overfill oil tank. This could cause oil
leaks and sluggish operation. Clean cap and
surrounding area before opening to prevent
dirt from entering tank.

CAUTION :

HOLDER

ENGINE OIL

DIPSTICK

Figure 9. Refueling

Table 4. Oil Selection Chart

-40

-30

-10
-20

-22
-40

-4

-14

0

32

50

68

86

104

122

10

20

30

40

50

F

C

5W/30

5W/40

10W

10W/30

10W/40

15W/40

20W/20

30

40

OIL: SAE

CAUTION :

Never operate the vibratory
roller in a confined area or
enclosed structure that does
not provide ample

free flow

of air.

BEFORE STARTING

1.

Read safety instructions at the beginning
of manual.

2.

Familiarize yourself with the operating
and control elements of the machine and
the working environment. This includes obstacles in the
working area, bearing capacity of the ground and the
necessary safety provisions.

3.

Check the air filter for dirt and dust. If the air filter is dirty, replace
air filter with a new one as required.

4.

Check fastening nuts and bolts for tightness. Loose threads
may cause damage to the machine when vibrating.

5.

Understand the geographical features and regulations of
the job site.

6.

Clean the vibratory roller, removing dirt and dust,
particularly, the bottom of the plate, engine cooling air inlet.

ALWAYS wear approved eye and hearing
protection before operating the vibratory roller.

3.

If the oil level is low, fill to the edge of the oil filler
hole with the recommended oil type (Table 4).
Maximum oil capacity is 2 quarts (1.9 liters).

Explosive Fuel

DANGER

Diesel fuel is highly flammable and can be dan-
gerous if mishandled. DO NOT smoke while
refueling. DO NOT attempt to refuel the vibratory
roller if the engine is

hot!

or

running.

Explosive Fuel

DANGER

Fuel spillage on a hot engine can case a

fire

or

explosion

. If fuel spillage occurs, wipe up the

spilled fuel completely to prevent fire hazards.

NEVER!

smoke around or near the roller.

Advertising
This manual is related to the following products: