Mellerware TRENTO 1200W - Manual (Page 4)

USING IT FOR THE FIRST TIME
• When first using this brewer, please carry out
a cleaning proceedure before it is pre-heated:
fill the container with water to the level marked
MAX, tighten the filter in place of brewer; turn
the switch to brewing mode
. At the same
time, place an adequate container under the
filter holder and make sure the two brewing
spouts are over the container. Now, you can
hear the motor of the pump rumbeling. Water
may take a while to come out of the spout if
you are using it for the first time, or if it has
not been used for some time. The cleaning
procedure is completed when half the water is
left in the container. now you can proceed to
the pre-heat proceedure.
PRE-HEATING THE COFFEE MACHINE
• For the proper function as well as longer life in
using the coffee brewer, remember to fill with
water before the heater mode
of the boiler
is turned on: by turning the selector switch to
brewing mode
, and wait until water drips
out from the spout.
• For optimum pre-heating the selector switch
can be left in the heater mode for
approximately half-an-hour before making
any coffee, as long as the filter holder is firmly
attached to the appliance (make sure the
steam release knob is closed).
• To install the filter properly, simply hold the filter
handle, flip handle clip backward and place it
level under the heater. Align the filter holder so
that the handle is pointing directly in fornt of
the heater. Now rotate the handle from left to
right until it is tight.
NOTE:
* Although the optimum pre-heating time for the
machine is 10 minutes when the selector is
in the heater mode
, the machine can be
operated after two minutes once the OK light
is lit.
* Fix the filter as tight as possible in the
installation to avoid water leaking from the filter.
HOW TO PREPARE ESPRESSO COFFEE
FILLING THE WATER TANK:
• To remove the water tank simply pull upwards
and fill the tank at the sink. Do not exceed the
MAX level on the water tank. The tank may also
be filled without removing it, simply by pouring
water into it directly from a jug.
• Replace the tank by connecting the valve at
the bottom of the tank with the hole in the base
of the machine.
NOTE: Do not operate the appliance without water
in the tank and always remember to fill the tank
when the water level goes below the MIN level.
The brewing of espresso requires several
attachment to be placed in the coffee filter. The
general operations are described as below:
2-cups coffee (with ground coffee)
a. Make sure the sealing ring has been placed in
the filter holder before fitting the 2-cups filter
basket;
b. Fill in the filter basket with appropriate amount
of ground coffee (12g recommended) and
follow general brewing procedures.
c. After brewing, grip the filter handle and
pressure reducer
firmly (hold for 5
seconds) when
removing the
filter holder, so
that the pressure
remaining in the
filter will be release
and the filter can
be removed safely.
NOTE:
* Please check if
the sealing ring
has been placed
properly in the
coffee filter before
fitting in the coffee filter basket.
* After brewing, remember to grip the pressure
reducer together with the filter handle firmly
when removing the filter so as to avoid the
danger of accidental pressure release.
* Every time after brewing, remember to clean
your coffee filter for hygene and for preventing
the coffee grounds from blocking the hole of
the reducer.
1-cup coffee (with ground coffee)
a. Make sure the one cup pressure valve
attachment has been placed in the filter holder
before fitting in the one cup filter basket;
b. Fill in the filter basket with appropriate amount
of ground coffee (6g recommended) and
follow general brewing procedures.
c. After brewing, grip the filter handle and