Micro Innovations PD7300LSR - Manual (Page 5)

USB Installation Procedures
STEP 1 - Remove the battery compartment cover located underneath the mouse and install the batteries into the mouse paying close
attention to the proper polarities. Carefully secure the cover and make sure the ON / OFF switch is in the ON position.
STEP 2 - Turn on your PC.
STEP 3 - Connect the RF receiver to an available USB port on your PC. Your PC will determine the correct settings for the mouse
to function.
By default, the Wireless Laser Mouse should communicate with the RF receiver. If by chance there is a source of
interference the mouse is experiencing, press the button on the RF receiver once and then, using a pen or pencil press
the CONNECT button located underneath the mouse.
STEP 4 - Insert the CD into an available CD-ROM drive and follow the onscreen instructions. Note some operating systems need
to be restarted in order for the program to function properly. It is recommended to restart your PC after installing this software
program.
Install Batteries Turn on PC Connect the RF Receiver Install Software
5