Motorola WDE1000 - Manual (Page 3)

iii
Regulatory Requirements
The Federal Communications Commission (FCC) requires
application for certification of digital devices in accordance
with CFR Title 47, Part 15 and Part 90. This includes Elec-
tromagnetic Energy Exposure (EME) testing. As the
WDE1000/1100 is not a stand-alone modem but is a PC
card/Mini PCI, the WDE1000/1100 cannot be tested by
itself for EME certification and was tested while inserted in
a laptop computer.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
The WDE1000/1100 transmitters, [email protected] and
802.11b/[email protected] will not work simultaneously when
used in the present configuration.
Safety and General Information
IMPORTANT INFORMATION ON SAFE AND EFFI-
CIENT OPERATION.
READ THIS INFORMATION BEFORE USING YOUR
MOTOROLA WDE1000/1100.
RF Operational Characteristics
Your Motorola product contains a radio frequency transmit-
ter to convey the information you wish to send as well as
occasional automatic signals used to sustain connection to
the wireless network, and a receiver which enables you to
receive communication and connection information from
the network.
Antenna Care (WDE1000 only)
Use only the supplied or an approved replacement antenna.
Unauthorized antennas, modifications, or attachments
could damage the radio product and may violate FCC regu-
lations. When using any approved accessory antenna, posi-
tion it at least eight inches (20 cm) from any part of any
person.
DO NOT hold the antenna when the radio product is "IN
USE". Holding the antenna affects communication quality
and may cause the product to operate at a higher power
level than needed.
Compliance and Control Guidelines and Operating
Instructions for WDE1100 Installed as Fixed Site
If WDE1100 is installed at a fixed location and operated as
a fixed unit, the antenna installation must comply with the
following requirements in order to ensure optimal perform-
ance and compliance with the RF energy exposure limits in
the standards and guidelines listed in “Product Operation
and EME Exposure” on page iv:
• The antenna should be mounted outside the building on
the roof or a tower if at all possible.
WDE1100 only.
WDE1100 is an OEM module and
is intended only for OEM integra-
tors under the following condi-
tions:
1.
The antenna should be
installed so there is at least
20cm of separation between
the body of the user and
nearby persons and the
antenna.
2. The OEM Module may not be
co-located with any other
transmitter or antenna.
3. The antenna installation of
this OEM Module, including
antenna gain, must satisfy the
requirements as specified in
FCC ID: AZ489FT7023 grant of
equipment authorization.
As long as the above conditions
are met, further transmitter tests
will not be required.
However, the OEM integrator is
still responsible for testing their
end product for any additional
compliance requirements required
with this Module installed.
If the above conditions can not be
met then the FCC authorization is
no longer considered valid and
the FCC ID can not be used on the
final product.
In this case, the OEM Integrator
will be responsible for re-
evaluation of the end product,
including the transmitter, and
obtaining a separate FCC
authorization.
NOTE
WDE1000 only.
The WDE1000 was approved by
the United States Federal Commu-
nications Commission (FCC) for
use with internal on board
antennas.
For external antenna use in the
United States, the Federal
Communications Commission
(FCC) requires that an approval
will be obtained.
NOTE