Df-1250t deep fryer, Cleaning instructions, Operation of timer – Nesco DF-1250T User Manual

Page 6: Battery replacement for timer

Advertising
background image

6

DF-1250T Deep Fryer

Cleaning Instructions

1. Always unplug appliance, detach the Breakaway Cord

and let the oil cool down to room temperature

before cleaning.

2. Remove lid.

3. Lift out basket.

4. Lift Heater Assembly up from backside of fryer. Carefully lift Oil Reservoir out by holding the rim. Pour oil into

suitable container.

5. The Basket, Lid, and Oil Reservoir are dishwasher safe. Dry parts thoroughly after cleaning.

6. The body is submersible and should be washed by hand with warm soapy water.

7. The Heater Assembly should never be immersed into water or other liquids. Clean the outer surface of the Heater

Assembly with a damp cloth, containing mild soap solution or plain water.

8. Ensure that both the Lid and the Oil Reservoir are completely dry after

washing and before use. See Illustration at right for best draining
position of Lid.

9. After cleaning, reassemble Oil Reservoir, Heater Assembly, Basket and

Lid to fryer. The Heater Assembly must be attached properly to the
back of the Body or appliance will not operate.

10. For storage, basket handle can be folded down to fit inside reservoir.

Operation of Timer

1. This timer counts down. It can be set from 1 to 99 minutes.

2. To set timer, press button until the LCD display shows “0” and continue pressing the button momentarily to

advance the timer by one minute per press. To advance more than one minute per press, hold the button down.

3. Timer will start 2 seconds after you stop pressing the button.

4. The timer can be reset to zero or be turned off while it counts down. Press the button to reset the LCD display

until it shows “0”.

5. The timer beeps when it reaches zero and will beep again after 20 seconds. The timer will turn off automatically.

However, timer does not shut off unit.

Battery Replacement for Timer

1. Replace battery (type LR44) when display dims or alarm gets weak.

2. Remove timer from Heater Assembly by holding edges and pulling out.

3. Slide off battery cover and replace with new LR44 battery. The “+” mark should face out when battery is inserted

correctly.

4. Close battery cover by sliding back into place. Reinsert timer into compartment in Heater Assembly.

5. Do not recharge battery or dispose of in a fire.

65029 MW DF-1250T #66239 10/25/01 2:38 PM Page 6 Sally Mercury:65946 Metalware books:66239:

Advertising