Magnadyne M1-LCD - Manual (Page 47)

47
The LCD display may fail to function normally
due to the vehicle’s battery condition, and could
require resetting the radio’s microprocessor if:
• The vehicle has been “jump started” from a
dead battery condition.
• The vehicle battery becomes very low and is
quick-charged.
• The vehicle battery is removed and replaced.
Reset Button
If the fuse should blow, check that the wiring is correct. If the wiring is correct, replace the fuse with
the same amperage rating as the original (15 amp).
Replaceable Fuse
15 Amp Replaceable Fuse
Should any of these conditions occur, simply
press and release the RESET button on the radio
front panel using the tip of a ball point pen. This
will reset the radio microprocessor to the origi-
nal factory settings. After pressing the RESET
button, you should recheck to see if the radio
functions normally.
M1-LCD-UM Rev. B (RGB):9900CD Manual 9/3/08 10:42 AM Page 47