Monster Power HTS3000 - Manual (Page 30)

26
Possible Cause #3
The PowerCenter Slow Blow 5A digital filter fuse is not installed.
Possible Solutions
• If you lose or run out of the replacement fuses provided with the PowerCenter,
go to your local electronics store and buy a Slow Blow 5A 5X20mm fuse.
• To install a fuse, secure it in the fuseholder cap and push fuse and cap into receptacle.
Turn clockwise until tight with a flat head screwdriver.
Possible Cause #4
A power overload occurred, throwing the Thermal Circuit Breaker.
Possible Solution
• Press the PowerCenter Thermal Circuit Breaker button in to reset. Please allow 10 minutes
before attempting to reset. If you reset too soon, the breaker will prematurely sense
a power overload and not allow the unit to operate.
Possible Cause #5
The PowerCenter cord is plugged into an outlet on the back of one of your components and the component
is not turned On. For the best possible performance, plug the PowerCenter into a wall unit, not another component.
Possible Solution
• Turn the component power On.
Possible Cause #6
Your PowerCenter is defective.
Possible Solution
• Please see the section marked ”Warranty Information“ for actions to take.