MaxTech XT5861 User Manual
Page 5
4
• Plug the 15-pin male connector on the video cable into the output
connector on the rear of your computer system. The video output
connector on your computer may be either in a location similar to
Figure 2-2
or on an expansion board. Secure the cable to the
computer using the thumbscrews on the 15-pin connector.
• Attach the power cord to the monitor and plug it into an AC outlet.
• The monitor is now ready for use.
Section 3 - Monitor Controls and LEDs
1.
Power Indicators: LEDs A and B indicate the state of the Monitor.
•
LED A On (green) Normal operations.
•
LED A flashing DPMS (Display Power Management Signaling)
“STAND-BY” mode.
•
LED B On (orange) DPMS “OFF” mode.
2.
Power Switch: Push to turn the monitor ON, push again to turn the
monitor OFF.
3.
Trapezoid: Adjusts the angle of the sides of the display to make the
display rectangular.
4.
Pincushion: Adjusts the curvature of the sides of the display to make
the sides straight.
5.
Vertical-Position: Adjusts the vertical position
A
B
1
2
3
4
5
6
7
10
9
8
Figure 3-1 Controls and LEDs