Marmitek 4 - Manual (Page 5)

5 EASYCONTROL 4
ENGLISH
[6] VOL +/-
Controls the volume. You can adjust the volume, also when you are in VCR, DVD or SAT
mode. You do not need to switch over to TV mode.
[7] INFO
Provides on-screen information for the device selected (if available).
[8] SETUP
This is where you program the remote control for use. This button gives access to some
of the secondary functions of certain audio/video equipment (Shift). Press the SETUP but-
ton and then the desired function button.
[9] Numeric keys 0-9
These work just like a normal remote control.
[10] AV
Selects an external audio or video source (via the A/V or Scart in).
[11] -/--
This button allows you, on some devices, to choose channels that have a number higher
than 9 (two digits). If you are using the Setup mode and are automatically searching for
codes, you can use this button to enter the code for the device.
[12] MENU
Activates the menu.
[13] EXIT
Exits the menu.
[14] OK
Confirms the menu selection.
[15] Navigation buttons
Up, down, left, right, to be used to navigate through the menu (TV, DVD etc.).
[16]
Teletext ON: Start/stop Teletext.
Teletext OFF: Stop teletext.
Teletext Hold: Hold the page in Teletext mode.
Teletext Mix (TVand SAT): Shows Teletext and the images of the selected channel.
[17] REW (rewind)
In VCR, DVD or SAT mode: Works just like the button on the original remote control.
In TV mode: Coloured button (red), operates Teletext – or other device functions.