MACKIE PPM1008 - Manual (Page 9)

9
Owner’s Manual
Owner’
s Manual
Large Band System
This diagram shows microphones attached to the mic inputs of channels 1 to 4, electric guitars
connected directly to ch. 5 and 6 (with hi-z switches pressed in), a guitar processor connected to ch.6
insert, a keyboard attached to channel 7's stereo inputs, and an electronic drum kit attached to channel
8. Add vocal compression as required, by tweaking the compression knobs on channels 1 to 4.
The power amp mode switch is set to play the monitor 1 mix on channel A, and monitor 2 mix on
channel B. Note: Press in the front panel FX send/mon 2 send switch, or monitor 2 will not play.
C200 passive stage monitors are connected to the channel B speaker-level power output of the
powered mixer. These play the stage monitor mix 2 to your performers. C300z passive stage monitors
are connected to the channel A speaker-level power output, and play stage monitor mix 1.
Mackie HD1531 powered speakers and HD1801 powered subwoofers are connected to the line-level
main mix outputs, and play the stereo main mix to your audience.
Microphones
press HI-Z
buttons
Guitar Processor
(connected to INSERT)
Send
Return
Keyboards
C300z Passive Stage Monitors
(plays mon 1 output)
HD1531
Powered
Speaker
HD1531
Powered
Speaker
C200 Passive Stage Monitors
(plays mon 2 output)
Rear Panel
Front Panel Power Amp Mode
switch set to
Mon 1/Mon 2
Adjust
Vocal
Compression
Electronic Drum Kit
HD1801
Powered Subwoofer
(plays left main mix)
HD1801
Powered Subwoofer
(plays right main mix)