Motorola LS550 - Manual (Page 9)

31
Connect Function
The menu selection CONNECT is intended for use by service personnel only.
When selected, an alternating pattern of is displayed. To exit this
screen, press any button twice and the pager restarts.
Message and Pager Indicators
Your pager has several indicators to inform you of the status of your
messages and your pager.
Duplicate Message
When a new message is received that is identical to one already stored,
the older message is overwritten by the new one.
DUPLICATE is displayed
before the new message and new time stamp.
Errored Data
When a message is received that might contain errors, the characters likely
to be in error flash when the message is read.
Alarm
The alarm icon l is displayed when the alarm is set and flashes during the
alarm alert.
INDICATORS
C
C C
C
32
Memory Full
When the pager memory is full, for example, all message locations are
occupied,
MEM FULL is displayed on the Standby screen until a button is
pressed. When this occurs, delete your old unwanted messages to make
room for newer messages.
MEM FULL is also displayed if you try to move a
message into the message folder when there is not enough storage space
left.
Note: If you don’t delete any old messages, the pager automatically
deletes the oldest read message to make room for the new
message.
Low Battery
When the voltage of the pager’s battery drops below a certain level, b is
displayed on all screens, even when the pager is off. The low-battery
condition is displayed until the battery is replaced.
Note: Check your pager’s clock time after replacing the battery.
INDICATORS
33
Belt Clip
Your pager has a removable belt clip. To remove and replace the belt clip,
follow the instructions below.
Removing the Belt Clip
➊ Insert the pointed end of a non-metallic
item (such as a pen cap) into the top end
of the belt clip as shown in the
illustration.
➋ Push upward on the tab and slide the
belt clip forward to separate it from the
pager.
Replacing the Belt Clip
➊ Align the belt clip with belt clip holder.
➋ Slide the belt clip into the holder until it snaps back into place.
Lift tab up to
release
belt clip
BELT CLIP
34
Cleaning Your Pager
To clean smudges and grime from the exterior of your pager, use a soft,
non-abrasive cloth moistened in a mild soap and water solution. Use a
second cloth moistened in clean water to wipe the surface clean. Do not
immerse in water. Do not use alcohol or other cleaning solutions.
USE AND CAR
E