Murray 11052x4NC - Manual (Page 7)

ASSEMBLY
7
F–041306C
ASSEMBLY
PARTS PACKED SEPARATELY
IN CARTON
1 – Owner’s Manual (not shown)
1 – Upper Handle
1 – Right Lower Handle
1 – Left Lower Handle
1 – Parts Bag
WARNING: Always wear safety
glasses or eye shields while as-
sembling the cultivator.
Figure 1 shows the cultivator completely as-
sembled.
References to the right or left side of the cul-
tivator are from the viewpoint of the opera-
tor’s position behind the unit.
HOW TO REMOVE THE
CULTIVATOR FROM THE CARTON
1. Remove the parts bag from the carton.
2. Remove the handles from the carton.
3. Remove the packing material positioned
around the unit.
4. Lift the cultivator out of the carton and
place on a hard level surface.
5. Remove the packing material from the
tines.
Figure 1
HOW TO
ASSEMBLE THE HANDLE
The lower handles have a short bend at the
bottom and have been flattened at the top.
1. Unwind the throttle control from around
the engine. Straighten the throttle cable.
Make sure that you do not bend or kink
the cable.
2. Remove the locknuts, washers, and
screws from the tine shield (see
Figure 2).
Figure 2
Locknuts
Washers
Bolts
Washers Tine Shield