Declaration of conformity – Measurement Specialties PCI-2513 User Manual
Page 33
Declaration of Conformity
Manufacturer: IOTech, Incorporated
Address: 25971
Cannon
Road
Cleveland,
OH
44146
USA
Category:
Information technology equipment.
IOTech, Incorporated declares under sole responsibility that the product
PCI-2513
to which this declaration relates is in conformity with the relevant provisions of the following standards or other
documents:
EU EMC Directive 89/336/EEC: Electromagnetic Compatibility, EN 61326 (1997) Amendment 1 (1998)
Emissions: Group 1, Class A
EN 55022 (1990)/CISPR 22: Radiated and Conducted emissions.
Immunity: EN61326, Annex A
IEC 61000-4-2 (1995): Electrostatic Discharge immunity, Criteria B.
IEC 61000-4-3 (1995): Radiated Electromagnetic Field immunity Criteria A.
IEC 61000-4-4 (1995): Electric Fast Transient Burst immunity Criteria B.
IEC 61000-4-5 (1995): Surge immunity Criteria A.
IEC 61000-4-6 (1996): Radio Frequency Common Mode immunity Criteria A.
To maintain the safety, emission, and immunity standards of this declaration, the following conditions must be
met.
Part CA-68-3S or CA-68-6S must be properly installed.
The host computer, peripheral equipment, power sources, and expansion hardware must be CE compliant.
All I/O cables must be shielded, with the shields connected to CHASSIS ground stud.
I/O cables must be less than 3 meters (9.75 feet) in length.
The host computer must be properly grounded.
Equipment must be operated in a controlled electromagnetic environment as defined by Standards EN
61326:1998, or IEC 61326:1998.
Note: Data acquisition equipment may exhibit noise or increased offsets when exposed to high RF fields
(>3V/m) or transients.
Declaration of Conformity based on tests conducted by Smith Electronics, Inc., Cleveland, OH 44141, USA in
December, 2005. Test records are outlined in Smith Electronics Test Report “Daqboard 3000 with PDQ30
Expansion Module”.
We hereby declare that the equipment specified conforms to the above Directives and Standards.
Paul Wittibschlager
Director of Hardware Engineering