MITSUBISHI ELECTRIC DLP HC1100 - Manual (Page 5)

5
[Example 1] When setting the AUTO POWER ON to ON. (Figures and symbols enclosed in quotation
marks are ASCII codes.):
[Example 2] When setting the R data to +10, G data to 0, and B data to -5:(Figures and symbols enclosed in
quotation marks are ASCII codes.):
Sending commands Status code from Description
from the PC, etc. the projector
30 30 50 2B 31 30 2B 30 30 2D 30 35 0D Command for setting the
'0' '0' 'Q' '+' '1' '0' '+' '0' '0' '-' '0' '5' ' ' picture control
30 30 50 2B 31 30 2B 30 30 2D 30 35 0D Command receipt confirmation
'0' '0' 'Q' '+' '1' '0' '+' '0' '0' '-' '0' '5' ' ' (Command echo back)
Sending commands Status code from Description
from the PC, etc. the projector
30 30 41 50 4F 4E 31 0D Command for setting the
'0' '0' 'A' 'P' 'O' 'N' '1' ' ' AUTO POWER ON to ON
30 30 41 50 4F 4E 31 0D Command receipt confirmation
'0' '0' 'A' 'P' 'O' 'N' '1' ' ' (Command echo back)
The data code of BRIGHTNESS of USER of COLOR TEMP. consists of the R, G and B data.
[Example 3] When checking the TINT setting (when the TINT is set to +10). (Figures and symbols enclosed
in quotation marks are ASCII codes.):
Sending commands Status code from Description
from the PC, etc. the projector
30 30 53 0D Command for checking
'0' '0' 'S' ' ' the TINT setting
30 30 53 2B 31 30 0D Check result (+10)
'0' '0' 'S' '+' '1' '0' ' '
• To set TINT at 0, enter +00. (-00 is invalid.)
[Example 4] When setting the REFERENCE of GAMMA MODE - USER 1 to CINEMA, HIGH to -2, MID to
+3 and LOW to 0. (Figures and symbols enclosed in quotation marks are ASCII codes.):
Sending commands Status code from Description
from the PC, etc. the projector
30 30 47 53 55 31 2B 32 20 30 32 2B 30 33 2B 30 30 OD Command for setting the
'0' '0' 'G' 'S' 'U' '1' '+' '2' '-' '0' '2' '+''0' '3' '+' '0' '0' ' ' REFERENCE of GAMMA MODE
30 30 47 53 55 31 2B 32 20 30 32 2B 30 33 2B 30 30 OD Command receipt confirmation
'0' '0' 'G' 'S' 'U' '1' '+' '2' '-' '0' '2' '+''0' '3' '+' '0' '0' ' ' (Command echo back)