Miele DA 3190 EXT EN - Manual (Page 26)

^ Screw the brackets onto the right and
left inside walls of the housing unit as
shown. The back edge of the
brackets should align with the vertical
line drawn up from the front of the
spacer strip, and the lower edge
aligned with the lower edge of the
housing unit side wall.
The brackets are designed for 16
and 19 mm thick carcase sides.
Orientate the bracket so that the
vertical depth matches the thickness
of the panel, as shown.
^ Place the appliance on its back.
Do not remove the protective film
between the deflector plate and the
casing until the hood has been
placed in the housing unit.
^ Hold the grease filter firmly, and pull
it out with the deflector plate as
shown.
^ Remove the grease filter and place to
one side.
^ Push the deflector plate back in.
Installation
26