Magnadyne MOBILEVISION C-SDL - Manual (Page 3)

3
Troubleshooting
Symptoms Solutions
Cloudy Image
No Power / Image
Upside Down Image
Unstable Image
• Clean Dirty Camera Lens
• Check Power Connections
• Check Camera Mounting
• Check Mounting Hardware
• Check Power Connections
Maintenance
Although this Side View Security Camera requires little care, you can still maintain its condition and
performance by following these steps:
• Occasionally clean the camera lens with damp soft cloth.
Should you experience any problem with the camera please refer to the troubleshooting guide
below prior to returning your camera for repair.
Note: The user should not attempt to service the unit beyond that described in the operating
instructions. All other servicing should be referred to qualified personnel.
Warning
Backing Up Your Vehicle
The product is intended to assist in safe driving and allows the driver to have a broader field of
vision during backup. You, as the driver, are solely responsible for the safe operation of your vehi-
cle and the safety of your passengers and pedestrians, and abiding all state and local traffic regu-
lations. Do not use any features of this system to the extent it distracts you from safe driving. Your
first priority while driving should always be the safe operation of your vehicle. Magnadyne will not
accept any responsibility whatsoever for accidents and/or injuries resulting from failure to observe
these precautions or safety instructions.
Adjusting the Camera
Adjustment Screws
Do Not Adjust
Do Not Adjust
Marking on Camera
Housing Indicates
Up Position
1. With the housing removed, loosen the
adjustment screws located near the base of
the camera.
2. Adjust the camera to the desired viewing
angle.
3. Tighten the adjustment screws to lock
camera into place.
Note: Do not over tighten the screws.
4. Reinstall the housing.
C-SDL_R-UMIM 3/20/08 2:58 PM Page 4