3 testing the path to the boot lun, Testing the path to the boot lun, Figure 22 save your changes – McDATA 8832 User Manual
Page 21: Figure 23 confirm the media is accessible
IBM BladeCenter Deployment Guide
Figure 21 Save your changes
Critical Note:
At this point, only one boot path is configured. During the INITIAL
Operating System build, only one boot path should be active. After the initial OS build a
secondary path can be added if this is supported by the storage vendor.
3.2.3 Testing the path to the boot LUN
The path to the LUN that the server will be booting from can be tested at this point.
• Select verify disk media
• Once the boot media is verified, save changes and exit.
Figure 22 Confirm the media is accessible
Version 3.0, 3/10/2006
http://w3-03.ibm.com/support/techdocs/atsmastr.nsf/WebIndex/WP100564
The BladeCenter Deployment Guide is intended as a personal productivity tool. It is not intended to be comprehensive and is provided for
guidance only, on an 'as is basis' without warranty of any kind. Please be aware that its contents have not been certified by IBM.
21