Multitech MULTIMODEMII MT5600BAV.90 - Manual (Page 27)

Chapter 3 - Using the Front Panel
27
MT5600BA/BL Series User Guide
Remote Configuration Options
The following screens are used to configure remote configuration options. For more
information about remote configuration, see Chapter 5, “Remote Configuration.”
ENABLE/DISABLE R.C. Use the à and Enter buttons to turn
remoteconfiguration on or off.
REMOTE CONFIG. PASSWORD. Use to enter the remote con-
figuration password. To scroll through a list of digits and char-
acters, press the
áß and â buttons. To go to the next position,
press the
à button. To back up or to exit without saving, press
the à button several times. To save the password, press the
Enter button.
Diagnostic Options
Use the following screens to turn loopback tests on and off. For information about
how to apply these tests, see Appendix C, “Loopback Tests.”
ANALOG LOOPBACK. Press the
à and Enter buttons to start
the analog loopback test. The TEST IN PROGRESS screen
appears. To stop the test, press the
à and Enter buttons again.
DIGITAL LOOPBACK. Press the
à and Enter buttons to start
the local digital loopback test. The TEST IN PROGRESS
screen appears. To stop the test, press the
à and Enter buttons
again. Same as the &T3 command.
REMOTE DIGITAL LOOPBACK. Press the
à and Enter but-
tons to start the remote digital loopback test. The TEST IN
PROGRESS
screen appears. To stop the test, press the
à and
Enter buttons again. Same as the &T6 command.
Phone Number Memory Options
Use the following screens to list, enter, and dial stored phone numbers. Up to four
phone numbers can be stored. The number in memory location 0 is used for DTR
dialing, if DTR dialing is enabled. Note: Only 16 characters can be displayed at a time.
To display characters 17–30, press the
â button. To go to the previous screen, press the
ß button. To go to the next screen, press the à button.
LIST PHONE NUMBERS. Press the
à button several times to
display the phone number stored in each memory location.
ENTER PHONE NUMBERS. Use to store up to four phone
numbers in memory locations 0–3. Each number can have up to
30 characters. To scroll through a list of digits and characters,
press the
áß and â buttons. To go to the next position, press
the à button. To back up or to exit without saving, press the à
button several times. To save the number, press the Enter but-
ton. Same as the &Z= commands.
DIAL STORED NUMBERS. Press the
à and Enter buttons to
dial a stored phone number. Same as the DS= commands.