M&S Systems PSW112 - Manual (Page 7)

Page 6 PSW112 Owners Manual M&S Systems Page 7
Speaker Level Connections
The Speaker Level Output has a 100Hz built-in high pass
filter.
The PSW112 Speaker Level Connections are shown in the
picture below and can be found on the back of the
subwoofer.
Line Level Connections
The PSW112 Line Level Connections are shown in the
picture below and can be found on the back of the
subwoofer.
Plug in the PSW112 power cord. Do not plug the PSW112
subwoofer into a switched outlet on your receiver. The
PSW112 has an automatic stand-by circuit to ensure prompt
power up and connecting the unit to a switched outlet will
delay the output and lead to noise on power down.
3. Connect using speaker wires – Connect the wires
from the amplifier to the “Speaker Level Inputs” and
the wires going to the speakers should be connected
to the “Speaker Level Outputs”.
IMPORTANT! Make sure there are no loose
strands of wire touching each other across the
speaker or amplifier terminals. This can create a
short circuit and damage your electronics.
115934B.pdf 6115934B.pdf 6
1/3/2006 10:46:25 AM1/3/2006 10:46:25 AM