Midland Radio NAUTICO 3 - Manual (Page 9)

®
Page 9 www.midlandradio.com
NAUTICO3 QUICK REFERENCE CHART
MONITOR
Pressing and holding the MONITOR button for 1 second will let you
hear noise so you can adjust the volume level of the radio when not
receiving a signal. This should be used to check activity on your
current channel before transmitting. Press and release the MONITOR
button for 1 second to get out of MONITOR mode.
SCAN
Your NAUTICO3 can scan all channels for activity. To enter, quickly
press the SCAN button. Repeat the same procedure to exit. Your radio
will rapidly scan each of the channels and stop on any active channel
for 5 seconds before resuming scan. When you press the PTT button
to transmit on an active channel, the scanning function will stop and
remain on the active channel. To resume scanning, quickly press the
button.
INSTANT CHANNEL 16/9
Channel 16 (Distress Channel) is used for calling other stations or
for distress alerting. You must monitor Channel 16 while standing by.
Channel 16 is only to be used in emergency situations. You can also
switch to Channel 9, the leisure-use call channel, without changing
your normal channel by pressing and holding the CH16 Button for 1
second. Pressing the CH16 button again returns the radio to the
normal channel setting.
CALL ALERT
Your NAUTICO3 can transmit a call alert for a fixed length of time. To
send a call alert, press the PTT button twice within ½ second. The TX
icon will appear while transmitting a call alert and a tone can be heard
on the speaker for confirmation.
Model NT3 Series
MENU Channel Keylock
On/Off
Power
Hi/Lo
Roger Beep
On/Off
eVOX
oF/1/2
Call Tone
1~3
WX Channel
1~10
Press &
hold Menu
button
CHANNEL SELECTION
INT/USA/CAN
WX Alert
On/Off
/ *
*
depends on CHANNEL SELECTION
/