Motorola E816 - Manual (Page 56)

PAGE 55 PERSONALIZING FEATURES PHONE FEATURES
Use the Call command to place a call in 2 different ways:
• Dial a Contacts entry by speaking the name of the entry.
• Dial any number by speaking the digits in the number.
1. Press and release the voice button on the right side of the phone.
You phone displays Say a command, followed by a list of speech commands.
2. Say “Call,” then say the name of the Contacts entry, or speak the digits of the phone number.
• For example, to call the mobile number for a Contacts entry named Bill Smith, you would say “Call Bill Smith
mobile.” (If the entry included only 1 number for Bill Smith, you would simply state “Call Bill Smith.”)
• Similarly, to call the phone number 312-555-1212, you would say “Call 312-555-1212.”
If the phone recognizes the name or number, it places the call.
• If the phone asks you to repeat a name or number, say it again. If the name or number is not valid or is not
recognized, the phone does not place the call.
• If the phone does not recognize the name or number, it displays a list of up to 3 names or numbers, asks, “Did
you say ...,” and highlights that first item in the list.
• If the name or number is correct, say “Yes” to place the call.
• If the name or number is not correct, say “No” to go to the next item on the list.
• To select the name or number manually, scroll to the name or number on the list and press the Select key.
• To exit the list, say “Cancel.”
• If you reach the end of the list without confirming a number, the phone says, “Sorry, no match found.” To try
to place the call again, press the Repeat key, say “Call,” and clearly speak the name or number.
Tip: Speak numbers at a normal speed and volume, pronouncing each digit distinctly. Avoid pausing between digits.